OPT7 Aura Golf Cart Underglow LED Lighting Strips Kit, Neon Golf Car Underbody Accessories, RGB Multi-Color Mode Accent Lights kit with Wireless Remote and Key Chain, w/Switch, 10pc, 12V, Double Row

The kit comes with a lot of pieces consisting of 4″ LED strips, long and short extension wires, and splitters. While all of these pieces increase the install time, it provides many more options in how I was able to configure the lights. I also purchased the OPT7 Aura Expansion Pack along with this kit to install on my GEM e4. The control box has 4 connectors and I only used two connectors for my initial installation, so I have room for future expansion if I want to add more lights.The lights are bright and show very well at night. The LED strips are flexible and appear to be well built and have strong mounting tape on the back. I installed the light kit about 3 weeks ago and the mounting tape holding the LED strips to the frame is still holding strong. The remote controls work well with the control box and the kit as a whole has a wide range of colors. My daughter likes the mode that rotates through all of the colors with a fading transition.The wire connectors for the extension cables and LED strips are not waterproof, so it’s important to use the sections of heat shrink tubing included in the kit to seal the connections. The heat shrink tubing is lined with adhesive and difficult to remove after it has been heated, so you’ll want to make sure you don’t need to make changes to your configuration after the heat shrink is installed.My first step when installing the kit was to lay out the pieces and connect them together to ensure everything fit according to my plans. When connecting the pieces together, it’s also a good idea to slide a section of heat shrink tubing over one side. While keeping the pieces connected, I cleaned the areas I planned to attach the LED strips with rubbing alcohol. After the pieces with adhesive tape were installed, I slid the sections of heat shrink tubing over the connectors, used a heat gun with a heat shrink tubing attachment to seal the connections.For the control box, you’ll need to make sure you have a 12v power source. My GEM e4 has a 72 volt system, but luckily has a 12 volt terminal behind the dash that I could connect to. Otherwise, I would need to use a step-down transformer. After installing the control box behind the dash near the 12 volt terminal, I ran a set of the 48″ extension wires from each row of LED lights to the control box. The lights came on and operated perfectly during the first test. Overall, this kit is a great value and I am very happy with it.